7. Cues - Page 141
TitanUniversal_Man_v8-0_TT.doc 05 August 2014
2> Press [Quick Include] or [Advanced mode] if you want to
change the mode.
3> Press the Swop button of the cue you want to include into the
programmer. If you are in Quick Include mode, this Includes
the cue and finishes.
4> If you are in Advanced mode, all fixtures in the cue will be
selected. If you don’t want them all, deselect the fixtures you
don’t want. The fixtures in the cue are highlighted on the HUD
and on the fixture buttons.
5> Use [Set Mask] or the Attribute Bank buttons to select which
Attributes you want to include (All are included by default –
Softkey C turns them all off and D turns them all on). Softkey E
lets you include or exclude Shapes from the cue.
6> Press Enter. The selected attributes of the selected fixtures will
be loaded into the programmer.
7> Repeat from 2 to include other attributes from the same
fixtures, or repeat from 1 to include other fixtures.
• In Quick Include mode, you can set a mask for the include by
pressing one or more of the attribute bank buttons before you
select the cue to include.
7.3.5 Removing attributes from cues using “Off”
The “Off” button allows you to remove an attribute which has been
stored in a cue, as if you’d never recorded it.
For example, suppose you recorded a cue which had scans at a
certain position, with the colour set to green. If you later decide that
you don’t want a colour recorded at all in the cue, so that the colour
set by previous playbacks will remain, you set the colour values to Off
in the programmer, which when saved will remove those values from
the cue. You can also use the Off function to remove complete
fixtures from a cue by selecting all the attributes.
Setting an attribute to Off is not the same as recording an attribute at
zero, since this would change the attribute when the cue was fired. It
is the same as excluding that attribute using the mask when
recording, so the attribute will remain unchanged when the cue is
fired.
1> Press Off followed by the playback to be changed. (On consoles
which do not have a Release button, you need to press Off,
then [Off Console Values], then the playback)
2> Select fixtures to be set to Off.
3> Set the attribute mask to determine which attributes will be set
to Off.
4> Press the [Off] softkey.
You can also use Include to set values to Off.
1> Use the Quick Include function (described in previous section)
to load the cue you want to change into the programmer.
2> Press the Off button to display the Off menu.
3> All fixtures in the cue will be selected. If you don’t want to
change them all, deselect the fixtures you don’t want.
To Next Page
Loading...
