8. Chases - Page 159
TitanUniversal_Man_v8-0_TT.doc 05 August 2014
8.6.3 Cue linking
Option D sets how the cues in the chase are linked. The settings are:
• [Always Link Steps]: The chase will run on its own using the
times
• [Never Link Steps]: The chase will pause after every delay/fade
time for the user to press Go.
• [Link according to individual steps]: Each step in the chase will
obey its individual link settings which are set using the Playback
View window or the Unfold function.
When a chase is unlinked, raising the fader does not fire
the first cue, which can be a problem. To get round this,
if the chase is not looped, simply link the first cue to the
previous one. If the chase is looped, add a dummy step
at the end with 0 sec fade, 0 sec delay and link the first
step to this one.
8.6.4 Release between cues
The [Cue Release On/Off] option allows you to create an overlay
chase with gaps in it where the fixtures will return to their previous
state. For example you could create a chase where every alternate
cue sets the fixtures to white, with the in between cues being blank.
If this option is on, the fixtures will bump to white then return to the
colour set from a previous look.
8.6.5 Renumber cues
Option [Renumber cues] will renumber all the cues in the chase
starting from 1.
To Next Page
Loading...
