10. Running the show - Page 179
TitanUniversal_Man_v8-0_TT.doc 05 August 2014
10.1.5 Speed Masters
Playbacks can be assigned to a Speed Master which allow you to
control the speed of shapes or effects stored in a cue (or in the case
of chases, to modify the speed of the chase).
There are eight possible Speed Masters which allow you to separately
control the speed of different playbacks, if you need to.
A playback is assigned to a Speed Master by pressing [Playback
Options] then [Speed Source]. The following speed sources are
available:
• Local (default - no Speed Master)
• BPM 1-4 (override the local speed with a fixed value from the
master)
• Rate 1-4 (proportionally modify the local speed using the
master)
There is also a Rate Grand Master which, if used, proportionally
controls the four Rate Masters (BPM Masters are not affected).
To use Speed Masters you will need to assign some handles on the
console to act as the Speed Master faders. Switch the console to
System mode and select [Assign Mastering]. Special key profile
options are available for Speed Masters, BPM Masters default to Tap
Tempo.
10.1.6 Group Masters
You can assign a fader to control the master intensity of each fixture
group. To do this you simply save (or move) the group button to a
handle with a fader.
The blue button will then select fixtures in the group and holding the
blue button gives you softkey options to filter the selection according
to a pattern.
Press [Playback Options] and then the blue select button above the
fader to set the fader mode to the following:
• Scale master (proportional control). Scale masters can be set to
variable scales of 100%, 200%, 400%, 600% and 1000%. The
higher settings allow you to increase an intensity above its
recorded level.
• HTP (override level if higher than current output)
• Limit (sets hard limit)
• Take Over (place fixture and its intensity in programmer when
level matched)
• Disabled (ignore fader)
If the playback fader has a display area on the screen, the level and
mode of the master will be shown.
To Next Page
