Page 166 – 9. Cue Lists
TitanUniversal_Man_v8-0_TT.doc 05 August 2014
• If the View Tracking Values button is selected, tracking values
(values which have tracked through from another cue rather
than being stored directly in this cue) are shown in light grey.
9.3.3 Moving and copying cues
You can copy or move cues within a cue list or to other cue lists.
Either click and drag the cue in the Playback View window (press
View
then the select button for the cue list), or use Unfold (next section),
or you can use a command-line style series of keypresses.
Copy/Move within the same playback:
• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]
[AND <cue>] @ <cue> ENTER
• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]
[AND <cue>] ENTER <cue> ENTER
Copy/Move to the end of the same playback:
• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]
[AND <cue>] @ @
• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]
[AND <cue>] ENTER ENTER
Copy/Move to a different playback:
• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]
[AND <cue>] [@][ENTER] <playback> <cue> ENTER
Copy/Move to the end of a different playback:
• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]
[AND <cue>] [@][ENTER] <playback> ENTER
• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]
[AND <cue>] [@][ENTER] <playback> <playback>
(<playback> is a playback swop key, <cue> is the cue number and
sections in square brackets are optional)
9.3.4 Editing a cue list using Unfold
The Unfold button places each cue of the cue list on one of the
playback faders. This allows you to fire and edit each step individually
as if it was a stand-alone cue.
1> Press the Unfold button, then the Select button of the cue list to
be edited.
2> The first 10 cues are loaded into the playback faders. The
display shows the cue numbers and legends.
3> Raise a playback fader to output the contents of that cue (fade
times will operate as programmed).
4> Various Unfold options are available, the details are below.
5> Press Unfold again to get out of unfold mode.
• To edit the contents of a cue: Press Clear to empty the
programmer, raise the fader to output the cue, make the
changes, press [Record Step], then the Select button for the
cue number.
• To merge the programmer into the live step, double tap [Record
Step].
To Next Page
Loading...
