Page 16 – 1. Quick Start
TitanUniversal_Man_v8-0_TT.doc 05 August 2014
Switch to System mode by holding Avo and pressing Disk, press
[DMX Settings].
Select a Node on the left (where the DMX is going to), click the blue
arrow. On the right, select the DMX line it will be fed by. The ‘i’
buttons set properties for Nodes/Lines. (Section
5.5, p205).
To change the IP address of the console, press [Network Settings] in
System mode (Section
14.1.1, p217).
To change User Settings which let you personalise how the console
works, hold down Avo and select [User Settings] (Section.
12.3.3,
p
202).
To Next Page
Loading...
