12. User Settings and other options - Page 203
TitanUniversal_Man_v8-0_TT.doc 05 August 2014
always prompt, [Always Merge] - the console will never prompt
or [Palettes Always Merge] - the console will prompt unless you
are saving a palette.
• [Warn before parking fixtures …] sets the console action when
you patch a fixture which overwrites the DMX channels of
another fixture. This causes the overwritten fixture to be
“parked” The options are [Always] (console will warn you) and
[Never] (console will park the fixture without warning you).
• [Tempo Units…] sets the units for displaying tempo. The options
are [Beats per Minute] or [Seconds].
• [Connected View … Chase Speed] sets the console action when
you change the speed of a connected chase. [Connected View
Sets Temporary Chase Speed] means that the console will not
save the modified speed, and the next time the chase is fired it
will go back to its programmed speed. [Connected View Sets
Chase Speed] means that the console will modify the saved
speed of the chase.
• [Auto Connect…] sets whether Chases and Cue Lists will auto-
connect to the wheels when the playback is fired. The options
are [Off], [Chases], [Lists] and [Chases and Lists].
• [Channel Levels…] sets how you enter channel levels when
using numeric entry of levels. If set to [Channel Levels Set In
Tens], you enter one digit for the channel level (e.g. 5 = 50%).
If set to [Channel Levels Set in Units] you enter two digits, i.e.
50 = 50%.
• [Preload Time] sets a fade time for the Preload function,
normally 2 seconds. This value would normally be set for quiet
fixture movement.
• [Quick Palettes] enables or disables the Quick Palette function.
See section
5.2.3.
• [Press and Hold Fan] changes the Fan function so that it only
works while the Fan button is held. This avoids the common
user error of leaving Fan turned on accidentally.
• [Key Profiles] accesses the Key Profiles menu which can also be
found on the System menu. The option is here so that you can
access it using the Avo Shift button. See section
12.2.
• [LED Levels] sets the behaviour of the LEDs in the Select
buttons. This option only works on the Pearl Expert.
• [Timecode] This option lets you select the settings for glitch
detection, tolerance and timeout when using MIDI timecode.
• [Wheel sensitivity] The sensitivity of the encoder wheels, and
the pan/tilt threshold settings can be adjusted using this option.
Wheel sensitivity is adjusted using Wheel A and the current
level is shown on the display.
• [Add New Palette Channels to Playbacks] sets whether new
channels added into palettes will be added to playbacks using
those palettes.
• [Auto Groups] sets whether the console will automatically
create new groups for fixtures when you patch.
To Next Page
Loading...
