15. Using different Avolites consoles - Page 229
TitanUniversal_Man_v8-0_TT.doc 05 August 2014
The Titan software allows multiple timers for cues. This means in a
complicated show you can have lots of fades going on from different
cues each under the control of a different timer.
Playback priorities
You can configure how playbacks will behave if you turn on two
playbacks controlling the same fixture. For each playback, priority can
be set to Low, Normal, High or Very High. If a fixture is being
controlled by a playback and you turn on a playback of the same or
higher priority, then the new playback will take over. However, if the
new playback is set to lower priority than the first playback, the
fixture will not change.
This is useful if, for example, you’ve programmed looks using all your
fixtures, then you decide you want a couple of them to spotlight a
singer. If you set the Spotlight playback to be high priority, then
while it is active no other playback will affect the spotlight fixtures.
Undo/Redo
Undo/Redo buttons allow you to undo an action if you do something
and later regret it.
Release
When a playback is killed, you can set how the LTP channels release.
The default setting is to not release any attributes (i.e. LTP channels
will not change when the playback is killed), but you can set
attributes to revert to their state in the most recently active playback.
To Next Page
Loading...
