Field Service Manual December 2003
Page 102 of 276
9 If you do NOT wish to change other parameters, press short on
“Fn” button to return to parameter r000.
10 Press “P” to return to normal working conditions.
This is a list of important parameters.
par Description
r001
displays the actual frequency into P000
P003
User access level
P005
display selection on display
P010
commissioning parameter filter (access to group
of parameters
P304
rated motor voltage
P305
rated motor current
P307
rated motor power
P308
rated cos phi
P310
rated motor frequency
P311
rated motor speed
P340
calculation of motor parameters
P601
motor temperature sensor
P700
selection of command source
P701
function of digital input 1
P702
Function of digital input 2
P731
function of digital output 1
P844
BI : OFF2
P970
factory reset ( P010 = 30 )
P1000
selection of frequency set point
P1001
fixed frequency 1
P1040
set point of motor potentiometer frequency
P1082
maximum motor frequency
P1120
Ramp up time
P1121
Ramp down time
P1215
Holding brake enable
P1217
Holding time after ramp down
P1237
dynamic braking (with external resistor)
P1300
control mode
P3900
end of quick commissioning
Remarks
Parameter
explanation
To Next Page
Loading...