Baumer VCXG.2 Series - Sequencerconfigurationmode; Sequencerfeatureenable; Sequencerfeatureselector

11 | GenICam Camera Features Baumer
190 Operating Manual VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2 | V1.2
Sequencer configuration
In order to avoid overwriting current camera settings during Sequencer configuration, the cam-
era requires reparameterization to SequencerConfigurationMode.
If camera is set to SequencerConfigurationMode, individual Sequencer Sets can be selected via
SequencerSetSelector for configuration and saved by executing SequencerSetSave.
Starting the configured sequence requires switching the SequencerConfigurationMode = off to
enable SequencerMode.
11.15.1 SequencerConfigurationMode
Controls if the SequencerConfigurationMode is enabled.
Name SequencerConfigurationMode
Category SequencerControl
Interface IEnumeration
Access Read / Write
Unit -
Values On Enables SequencerConfigurationMode.
Off Disables SequencerConfigurationMode.
11.15.2 SequencerFeatureEnable
Enables the selected feature and make it active in all the Sequencer Sets.
Name SequencerFeatureEnable
Category SequencerControl
Interface IBoolean
Access Read only
Unit -
Values true = 1 (On)
false = 0 (Off)
11.15.3 SequencerFeatureSelector
Selects the camera features that are controlled by the Sequencer.
Name SequencerFeatureSelector
Category SequencerControl
Interface IEnumeration
Access Read / Write
Unit -
Values see table(s) below
VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2
Values (Features)
CounterDuration Height