Baumer VCXG.2 Series - Acquisitionmode; Acquisitionstart; Acquisitionstatus

Baumer GenICam Camera Features | 11
V1.2 | VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2 Operating Manual 79
11.1.5 AcquisitionMode
Sets the acquisition mode of the device. It defines mainly the number of frames to capture dur-
ing an acquisition and the way the acquisition stops.
INFO
The camera must be stopped before this feature can be edited.
Name AcquisitionMode
Category AcquisitionControl
Interface IEnumeration
Access Read / Write
Unit -
Values Continuous Without external events, image acquisition continues until stop by
command AcquisitionStop.
MultiFrame In this mode a predefined number of frames will be captured after
AcquisitionStart. The AcquisitionFrameCount controls the number
of captured frames. Next acquisition stops automatically.
Single-
Frame
In this mode the camera will acquire another image after Acquisi-
tionStart. Next acquisition stops.
11.1.6 AcquisitionStart
Once image acquisition has started, the camera processes the images in three steps:
1. Determining the current set of image parameters
2. Sensor exposure
3. Readout from the sensor
This process is then repeated until the camera is stopped.
Name AcquisitionStart
Category AcquisitionControl
Interface ICommand
Access Write only
Unit -
Values -
11.1.7 AcquisitionStatus
Reads the state of the internal acquisition signal selected using AcquisitionStatusSelector.
Name AcquisitionStatus
Category AcquisitionControl
Interface IBoolean
Access Read only
Unit -
Values true = 1 (On)
false = 0 (Off)