Baumer VCXG.2 Series - Binningverticalmode; Category: Imageformatcontrol → Calibrationcontrol (MP Cameras Only)

Baumer GenICam Camera Features | 11
V1.2 | VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2 Operating Manual 161
11.12.5 BinningVerticalMode
Sets the mode used to combine vertical pixels when BinningVerticall is used.
Name BinningVerticalMode
Category ImageFormatControl
Interface IEnumeration
Access Read / Write
Unit -
Values Average The response from the combined cells will be averaged, result-
ing in increased signal/noise ratio.
Sum The response from the combined cells will be added, resulting
in increased sensitivity.
11.12.6 Category: ImageFormatControl → CalibrationControl (MP cameras only)
Category comprising the polarization control features.
General information - Polarization
Polarization is used to reduce or eliminate unwanted reflections from surfaces such as water,
glass or metal. Polarization filters make incident light oscillate in a specific direction of polariza-
tion.
The Baumer polarization camera features a metal grid-coated sensor to filter the polarization in-
formation onto a 2 x 2 pixel field (0°, 45°, 90° and 135°).
The polarization information is calculated by intensity divergence. This eliminates the need for
an extra polarization filter.
The camera provides the raw polarization information. Calculation is done in Baumer GAPI
SDK.
135°
9
0°
45°
0°
Ill.6: Polarization filter on the 2 x 2 pixel field
Depending on the variant, the following data can be calculated by Baumer GAPI SDK :
Baumer GAPI
v2.9
Baumer GAPI
v2.10
Baumer GAPI
v2.11
Baumer GAPI
v2.12
ADOLP ADOLP ADOLP ADOLP
AOP AOP AOP AOP