Baumer VCXG.2 Series - Actiongroupmask; Actionselector; Category: Analogcontrol; Balancewhiteauto (Color Cameras Only)

Baumer GenICam Camera Features | 11
V1.2 | VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2 Operating Manual 91
11.2.3 ActionGroupMask
Provides the mask that the device will use to validate the action on reception of the action proto-
col message.
Name ActionGroupMask
Category ActionControl
Interface IInteger
Access Read / Write
Unit HexNumber
Values 0 - 4294967295 (Increment: 1)
11.2.4 ActionSelector
Selects to which Action Signal further Action settings apply.
Name ActionSelector
Category ActionControl
Interface IInteger
Access Read / Write
Unit -
Values 1 - 1 (Increment: 1)
11.3 Category: AnalogControl
Features in this chapter describes how to influence the analog features of an image, such as
Gain, BlackLevel and Gamma.
11.3.1 BalanceWhiteAuto (color cameras only)
Controls the mode for automatic white balancing between the color channels. The white balanc-
ing ratios are automatically adjusted.
Name BalanceWhiteAuto
Category AnalogControl
Interface IEnumeration
Access Read / Write
Unit -
Values Continuous White balancing is constantly adjusted by the device.
Off White balancing is off.
Once White balancing is automatically adjusted once by the device.
Once converged, it automatically returns to the Off state. The
levelling can take several images.
When images are acquired in TriggerMode, the white balance
affects on the next acquired image.