Baumer VCXG.2 Series - Gevscpsdonotfragment; Gevscpsfiretestpacket; Gevscpspacketsize

Baumer GenICam Camera Features | 11
V1.2 | VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2 Operating Manual 205
11.17.2.34 GevSCPSDoNotFragment
The state of this feature is copied into the "do not fragment" bit of IP header of each stream
packet. It can be used by the application to prevent IP fragmentation of packets on the stream
channel.
Name GevSCPSDoNotFragment
Category TansportLayerControl → GigEVision
Interface IBoolean
Access Read / Write
Unit -
Values true = 1 (On)
false = 0 (Off)
11.17.2.35 GevSCPSFireTestPacket
Sends a test packet. When this feature is set, the device will fire one test packet. The "don't
fragment" bit of IP header must be set for this test packet.
Name GevSCPSFireTestPacket
Category TansportLayerControl → GigEVision
Interface IBoolean
Access Read / Write
Unit -
Values true = 1 (On)
false = 0 (Off)
11.17.2.36 GevSCPSPacketSize
Specifies the stream packet size, in bytes, to send on the selected channel for a GVSP trans-
mitter or specifies the maximum packet size supported by a GVSP receiver.
Name GevSCPSPacketSize
Category TansportLayerControl → GigEVision
Interface IInteger
Access Read / Write
Unit Byte
Values > 0 (Increment: 2)