BCM RX680R - Network Stack Configuration

RX680R User’s Manual
70
Field Name
USB Mass Storage Driver Support
Default Value
[Enabled]
Possible Value
Disabled
Enabled
Help
Enable/Disable USB Mass Storage Driver Support.
Field Name
USB transfer time-out
Default Value
[20 sec]
Possible Value
1 sec
5 sec
10 sec
20 sec
Help
The time-out value for Control, Bulk, and Interrupt transfers.
Field Name
Device reset time-out
Default Value
[20 sec]
Possible Value
10 sec
20 sec
30 sec
40 sec
Help
USB mass storage device Start Unit command time-out.
Field Name
Device power-up delay
Default Value
[Auto]
Possible Value
Auto
Manual
Help
Maximum time the device will take before it properly reports itself to the Host
Controller. 'Auto' uses default value: for a Root port it is 100 ms, for a Hub port the
delay is taken from Hub descriptor.
2.2.10 Network Stack Configuration
Main
Advanced
Chipset
Security
Boot
Save & Exit
MEBx
Item help
Network stack
[Enabled]
Ipv4 PXE Support
[Disabled]
→←: Select Screen
Ipv6 PXE Support
[Disabled]
↑↓: Select Item
Enter: Select
+/- : Change Opt
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Reset
ESC: Exit
Version 2.21.1278. Copyright (C) 2021 AMI