A part of Australian history since 1893.
7
0
troUBleshooting
PROBLEM POSSIBLE CAUSE AND SOLUTION
The speakers produce a pop sound whenever the power is
turned ON or OFF.
This is normal and is no cause for alarm.
No sound when the keyboard is played. The R1/R2/L voice volume (Mixer) settings could be
set too low. Make sure the voice volumes are set at
appropriate levels.
When using a mobile phone, noise is produced. Using a mobile phone in close proximity to the instrument
may produce interference. To prevent this, turn off the
mobile phone or use it further away from the instrument.
The auto accompaniment does not play back even when
Sync is in standby condition and a key is pressed.
You may be trying to start accompaniment by playing a
key in the right-hand range of the keyboard. To start the
accompaniment with Sync Start, make sure to play a key in
the left-hand range of the keyboard.
Certain notes sound at wrong pitch. Make sure that the tuning value is set to 0 . Press and hold
the +/YES and [-/NO] buttons at the same time, then
turning the power on will set INSTRUMENT to default.
The Harmony function does not operate. Harmony cannot be turned on when a drum kit is selected
for the voice R1.
To Next Page
Loading...