EasyManua.ls Logo

BENDIXKing AeroNav 910 - Page 220

BENDIXKing AeroNav 910
426 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AeroNav 900/880 Series Pilot’s Guide
89000039-010
4-70 Map Subsystem Rev 1 May 2019
The “Stabilization” LSK is an on/off toggle of the radar’s gyro
stabilization.
When Radar is “On”, the controllable parameters are:
Range Use the outer ring of the bottom right knob to
control the displayed range scale.
Tilt Use the inner ring of the bottom right knob to control
the tilt angle and direction of the radar antenna: U for up via
right twists, D for down via left twists with the amount of
antenna tilt in 0.25° increments, using decimal notation.
Azimuth Push the bottom right knob to toggle between Tilt
and Azimuth control and then twist that knob to adjust the
azimuth or bearing line. The azimuth/bearing line is
controlled in increments of 1° and the relative bearing is
displayed in degrees relative to aircraft heading (if known)
where left has a “- indicator in front of the relative azimuth. It
will also control the radar’s “yaw” or lateral position of the
dish, when in vertical profile mode.

Table of Contents

Related product manuals