►
Start the drive motor using the ignition switch.
Hold the key in the Start position for max. 15 seconds. Release the key
immediately when the drive motor starts.
Release the key if the drive motor does not start.
►
Switch off the ignition.
►
Switch on the ignition
►
Wait until the
Pre-glow
indicator light goes out.
►
Start the drive motor using the ignition switch.
Contact customer service if the drive motor does not start (→ 13.1).
When the drive motor is running, all indicator lights on the instrument
panel must go out in the instrument panel. If an indicator light continues
to be lit, determine the cause and rectify it. Contact customer service if
necessary (→ 13.1).
8.4.1 Warming up the machine
At ambient temperatures < 0 °C, the drive motor and the hydraulic system
must be warmed up.
►
Move hydraulically controlled bodies against the stop several times for a
few minutes.
For example, raise and lower the rear tipping trough several times to do
this.
50-020-1011-900_EN
1.0 - © 2/15/2017
211
8 Operation
8.4 Switching on the machine
To Next Page
Loading...
