bergmann 4010 - Display Error Codes

Fault Possible cause of fault Troubleshooting
Significant leak at the hydraulic
connections or defective hydraulic
line.
►
Check the hydraulic system for
leaks and repair it if necessary.
Incorrect hydraulic settings.
►
Check the settings and correct
them if necessary.
Tab. 10.3: Malfunctions of the hydraulic system
10.2.4 Display error codes
The following warnings and error messages are output in the Warning/error
messages submenu (→ 8.2.5.4):
n Temp.Alert
n hyd. filter close
n Error Can BUS
n Error Transmissio
n Error Engine
If there is a fault in the engine, an SPN code and an FMI code are also
output.
50-020-1011-900_EN
1.0 - © 2/15/2017
264
10 Malfunctions and troubleshooting
10.2 Malfunctions