12 Taking out of operation, putting back into operation and dis‐
posal
12.1 Taking out of operation
►
Clean the machine thoroughly.
►
Drive/transport the machine to the location where it will be taken out of
operation.
►
Lubricate the complete machine.
►
Fill the transmissions of the travel drives fully with oil.
►
Fill the hydraulic tank fully with hydraulic fluid and seal it so it is air-tight.
►
Fill the fuel tank fully with fuel and seal it so it is air-tight.
►
Disconnect the electrical power supply at the battery main switch.
►
Apply corrosion protection to machined (unpainted) surfaces.
Further information about taking out of operation, see the individual third-
party documentation (→ part 3 of the documentation).
50-020-1011-900_EN
1.0 - © 2/15/2017
272
12 Taking out of operation, putting back into operation and disposal
12.1 Taking out of operation
To Next Page
Loading...
