Bernina 590 - 13 Embroidering Preparation; Attaching the Module; Removing the Embroidery Module

Embroidering preparation
144
13 Embroidering preparation
13.1 Attaching the Module
NOTICE
Transporting the embroidery module
Damage to the embroidery module connection and machine.
> Remove the embroidery module before transporting the machine.
Prerequisite:
• The slide-on table must not be attached.
> Make sure that the module and the machine are placed on a stable, even surface.
> Make sure that there is enough space around to allow the unimpeded movement of the embroidery arm.
> Carefully push the embroidery module from left to right into the embroidery module connection of the
machine (1) and the guide rail (2).
2
1
13.2 Removing the embroidery module
> Push the release lever (1) at the carrying handle of the embroidery module, keep it pressed and at the
same time, move the embroidery module carefully to the left.
1