Bernina 590 - Activating the Audio Signals; Machine Settings; Selecting a Language

Setup Program
66
> Touch the icon «Monitoring settings».
> Touch the switch in the lower portion of the display to deactivate the bobbin thread indicator.
> Touch the switch again to activate the bobbin thread indicator.
3.5 Activating the audio signals
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Audio signals».
> Touch the switch (1) to deactivate any audio signals in general.
> Touch the switch (1) again to activate any audio signals in general.
> In the section (2) touch the icons «1–4» to set up the desired signal for the selection of a stitch pattern.
> In the section (2) touch the icon «Loudspeaker» to deactive the signal for the selection of a stitch pattern.
> In the section (3) touch the icons «1–4» to activate the signal for the selection of functions.
> In the section (3) touch the icon «Loudspeaker» to deactivate the signal for the selection of functions.
> In the section (4) touch the icon «Loudspeaker» to deactivate the signal when using the BSR modes.
> In the section (4) touch the icon «Loudspeaker» again to activate the signal when using the BSR modes.
1
2
3
4
3.6 Machine settings
Selecting a language
The User Interface can be programmed in different languages according to the customer's wish because
BERNINA provides a wide range of international languages for the customers. Via firmware updates new
languages are provided for the User Interface as appropriate.
> Touch the icon «Home».