Bernina 590 - Error Messages

Attachment
190
17.3 Error messages
Message on the display Cause Repair
Stitch number unknown. > Check the entry and enter the new number.
Selection of the stitch pattern not
possible in the combi mode.
> Combine other stitches.
The feed dog is not lowered. > Push the button «Feed dog up/down» to lower the feed
dog.
The selected needle and stitch
plate cannot be used in
combination.
> Replace the needle.
> Replace the stitch plate.
The needle is not at its top end. > Adjust the needle position via the handwheel.
The upper thread is used up. > Rethread.
The upper thread has broken. > Rethread.
The bobbin thread is used up. > Rethread.
The bobbin thread has broken. > Clean the hook.
> Rethread.