Bernina 590 - Machine Setup and Configuration; Sewing Settings Configuration

Setup Program
56
> Touch the icon «Sewing settings».
> Touch the switch using the touchscreen pen/finger to deactivate the securing stitches.
> Touch the switch again to activate the securing stitches.
Adjusting the hovering height of the presser foot
The hovering height of the presser foot can be adjusted according to the fabric thickness from 0 to max. 7
mm (0.27 inch).
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Sewing settings».
> Touch the icon «Program buttons and icons».
> Touch the icon «Program the hovering position of the presser foot».
> Turn the «Upper Multifunction knob» or the «Lower Multifunction knob» or touch the icons «-» or «+»
to adjust the distance between the fabric and the presser foot.
Programming the button «Pattern end»
The presser foot can be positioned, the thread cut and the automatic securing can be programmed.
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Sewing settings».
> Touch the icon «Program buttons and icons».
> Touch the icon «Program the button Pattern end».
> Touch the icon «Securing» to program 4 securing stitches in place.