EasyManua.ls Logo

Bernina 830LE - Embroidery Template; Hooping the Fabric

Bernina 830LE
212 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
124
Preparation
Hooping the Fabric
Centering
determine the center ► of the fabric to be embroidered
mark with a fabric marker or chalk ►
Using the Embroidery Hoop
loosen the screw(s) ►
remove the inner hoop ►
the arrows on both hoops must match ►
the arrows on the large and medium hoops and on the ►
Mega Hoop are at the center front, on the small hoop,
they are to the right side
Embroidery Template
there is an embroidery template for each hoop ►
the embroidery area is marked in 3/8" (1cm) squares ►
the center and end point holes of the center lines are ►
with holes for transferring marks to the fabric
place the template in the inner hoop, so the BERNINA ►
logo is at the front edge (by the arrows) and can be read
placed in this way, the template sits automatically in the ►
inner hoop
the finger hole or the template holder make it easier to
►
remove the template from the hoop
Hooping the fabric
place the fabric on the outer hoop; line up the marked ►
center point on the center of the template
place the fabric and inner hoop on the outer hoop ►
match the arrows of both hoops ►
fit hoops into each other; ensure that the fabric does not ►
move
hoop the material to be embroidered tightly, tighten the ►
screw
remove the template ►
A
B
C

Table of Contents