20
Preparation
Changing the Needle
raise the needle ►
lower the presser foot and turn the power switch to «0» ►
Removing the Needle
loosen the clamp screw with the gray screwdriver and ►
pull needle down
Inserting the Needle
flat side of needle to the back ►
insert the needle with the mulitfunction tool as far as it ►
will go
tighten needle clamp screw ►
Changing the Presser Foot
raise the needle and presser foot ►
turn power switch to «0» (off) ►
Releasing the Presser Foot
raise the clamping lever ►
remove presser foot ►
Attaching the Presser Foot
guide the presser foot upwards over the cone ►
touch the clamping lever down ►
Turn the handwheel to lower the needle in
order to get better access to the fastening
screw.
To Next Page
