21
Preparation
Stitch plates
Stitch Plate Markings
the stitch plates are marked horizontally, vertically and ►
diagonaly in mm and inches
markings help with sewing e.g. precise seaming and top
►
stitching
horizontal markings are helpful for sewing corners and ►
buttonholes etc.
diagonal markings are helpful for Quilt piecing ►
the vertical markings refer to the distance from the ►
needle to the marking
needle insertion point is position «0» (= center needle ►
position)
measurements are marked to the right and to the left of ►
center needle position
Removing the Stitch Plate
raise the presser foot and needle ►
turn power switch to «0» (off) ►
press the stitch plate down at the right back corner ► B
until it flips up
remove stitch plate ►
Replacing the Stitch Plate
place the stitch plate over the opening ► A and press
down until it clicks into place
5.5mm (Optional accessory)
9mm
With each stitch the feed-dog moves forward one step. The
length of this step is determined by the stitch length
selected.
With a very short stitch length the steps are very short. The
fabric moves relatively slowly under the presser foot, even
at full sewing speed, e.g. buttonholes and satin stitch and
decorative stitches are sewn with a very short stitch length.
Let the fabric feed fabric evenly.
Pulling, pushing or holding back the fabric will result in uneven stitches.
Feed-Dog and Fabric Feed
A
A
B
B
To Next Page
Loading...
