169
Troubleshooting
Fault
Automatic threading not
possible
Double-needle limitation is on
Defective sensors
Switch off the double needle limitation in Security Program
Sewing-/embroidery computer checked by a dealer
Automatic thread cutter blocked
Thread remnants jammed in the thread Catcher Under Cleaning in Setup Program, proceed as follows:
touch field 1 ►
thread catcher of automatic thread cutter moves to the ►
right
carefully remove thread remnants with the tweezers ►
touch field 3 ►
automatic thread cutter re-initializes and is ready for use ►
Cause Repair
ExplanationGeneral Messages Repair
Clean and lubricate sewing-/embroidery computer Open bobbin cover and remove bobbin ►
Switch off sewing-/embroidery computer ►
Remove presser foot, needle and stitch plate ►
Clean sewing-/embroidery computer as indicated ►
Deleting or overwriting data, e.g. Drawers
Confirm with
or cancel with
To Next Page
