37
Setup Program
8
7
9
Needle Stop Adjustment
if the automatic thread cutter and the «raise presser ►
foot» function are switched off when securing, the
needle stop position 7 can be selected
standard = sewing computer stops with the needle up
►
while the presser foot stays down after securing
touch «Needle down» icon ►
the sewing computer stops with the needle down, the ►
presser foot is raised
Automatic Thread Cutter and Securing
Stitches
the number and type of securing stitches before the ►
thread is cut can be programmed
touch function ► 8 for securing stitches in place or function
9 for forward securing stitches
two to six securing stitches can be programmed ►
standard = no securing stitches programmed ►
Presser foot position when needle stop
down
with activated icon ► 1, the presser foot remains down
when the sewing computer stops
with activated icon ► 2, the presser foot is raised enough
to pivot the fabric (hover position)
with activated icon ► 3, the presser foot is raised into its
highest position
Hover position of presser foot
the stitch width and stitch length multi-function knobs ►
can be used to set the clearance from 0mm to 7mm in
maximum (standard clearance is 2 mm)
the set value, i.e. the clearance between the fabric and ►
the presser foot, is displayed in icon 4
1 2 3
4
To Next Page
