Section 1 Introduction
5
Section 1 Introduction
1.1 Safety Summary
General Warnings
Environmental Conditions
All system components require non-corrosive environmental conditions during
transportation, storage and commissioning.
Electrical Shock Hazard
Disconnect power to ensure that contact with energized part is avoided during in-
stallation and servicing.
Special Precautions
The measuring system electronics contains components that are highly sensitive
to electrostatic discharge!
Specific Warnings
Never change the installation or the parameter settings without a full knowledge
of the relevant part of this manual, the connected controller and the process, if it
is controlled by this measuring device.
Specific Cautions
This measuring device utilizes radioactive sources. Strict adherence must be
made with regard to the rules of Radiation Protection in this manual and the local
regulations pertaining to the use of radioactive sources.
Installation, dismantling, relocation, maintenance, testing involving the radioac-
tive source, or its shielding shall be performed by persons specifically licensed.
Radioactive sources, which are not in use have to be stored at a save place which
is tamperproof.
Ex Protection
All ex/protected resources may be repaired and serviced only by personnel
licensed by the manufacturer.
To Next Page
Loading...
