Appendix LB 983 NightSHADE II Operating Manual
118
10.1.3 Transilluminator
General Safety Instructions
When connecting the transilluminator to the power supply make sure to use a grounded mains
outlet!
Connect the transilluminator only to the power supply specified on the type label of the device!
Never leave the transilluminator powered up without any supervision!
Before carrying out any maintenance and repair work pull the power cord and make sure that all
parts of the device you may possibly come into contact with have cooled down to room temper-
ature!
Pull
power cord
Different types of transilluminators are available. For this reason, there are different safety in-
structions which have to be strictly observed.
To Next Page
Loading...