EasyManua.ls Logo

Beta RR 390 - Troubleshooting

Beta RR 390
360 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
TROUBLESHOOTING
70
GB
PROBLEM CAUSE
Engine does not start
REMEDY
- Fuel system clogged (fuel lines, fuel
tank, fuel cock).
- Air filter dirty.
- No current supplied to spark plug.
- Engine flooded.
Clean the system.
Proceed as described on page 48
Clean or replace the spark plug.
If the problem persists, contact a BETA-
MOTOR dealer.
Operate the start-up pedal 5-10 times or
the electrical starter pushbutton 2 times
every 5 seconds. If the vehicle does not
start, remove and dry the spark plug.
Engine misfires
- Spark gap wrongly adjusted.
- Spark plug dirty.
Restore the spark gap.
Clean or replace the spark plug.
Engine knocks
- Spark advance excessive.
- Carbon formation in cylinder
or on spark plug.
Check CDI: contact a BETAMOTOR
dealer.
Engine overheats and
loses power
- Silencer partly clogged.
- Exhaust port clogged.
- Ignition delayed.
Contact a BETAMOTOR dealer.
Contact a BETAMOTOR dealer.
Check CDI: contact a BETAMOTOR
dealer
Front braking poor
- Brake pads worn.
- Air or humidity in the hydraulic
circuit.
Rivolgersi ad un nostro Concessionario
Follow the procedure described on
page 40
Rear braking poor
- Brake pads worn.
- Air or humidity in the hydraulic
circuit.
Rivolgersi ad un nostro Concessionario
Follow the procedure described on
page 41
Contact a BETAMOTOR dealer.
TROUBLESHOOTING

Table of Contents

Related product manuals