59
Auto Mixers
Mute In turns the input signal on/off. Level In
adjusts the relative input volume. Ch / Bus assigns
inputs to the output. Mute Out turns the output
signal on/off. Level Out adjusts the relative output
volume.
Right-clicking over certain settings will provide a
menu of additional options. Unlike other
components, Mixers allow labeling of inputs/outputs
within their dialog boxes. See Channel Identifier
under Object Properties Sheet.
Mic Options opens a separate control dialog box to
establish global settings.
Designated Mic On / Last Mic Hold determines which
microphone (if any) will stay/become active when no signal is
present. Logic Outputs Follow Mic Logic assigns logic
outputs to follow Designated Mic On / Last Mic Hold. Open
Mic Limits enables (and designates) a maximum allowable
number of active microphones.
Right-clicking over Ch / Bus assignments allows selection of
two additional dialog boxes.
Channel Settings affects individual channel settings, but
may be applied to all channels. Manual turns on/off channel
gating. NOM Gain turns on/off channel contribution to NOM
(number of open mics) attenuation. Direct Output
designates channel direct output signal as Post Gate / Pre
NOM, Post Gate / Post NOM, or Off. (Direct Outputs must
be enabled when placing Auto Mixers from the Object
Toolbar.) Set All causes current Channel Settings to be
applied to all channels. Off Attenuation determines the
amount of attenuation applied when channel is inactive.
Gate Hold Time determines length of time before channel
becomes inactive, once signal is no longer present.
Logic Outputs affects individual Logic Output settings, but may
be applied to all Logic Outputs. (Logic Outputs must be
designated when placing Auto Mixers from the Object Toolbar).
Logic Output selects Follow Gate, On, or Off condition of the
Logic Output. Invert reverses operation of the Logic Output (off
when channel active). Set All causes current Logic Output
settings to be applied to all channels.
To Next Page
Loading...
