Binder vdl 23 - Ongoing Data Transfer; Error During Data Transmission; Removing the USB Stick

VDL (E3) 09/2019 Page 192/234
With the arrow-down button you can now change to the next function.
Function “Export service data”.
To write the chamber data from the controller to the USB stick, press
the OK button.
Export service data
22.3.4 Ongoing data transfer
A moving arrow symbol indicates the progress of the data transfer.
Example:
Data recording is running.
Export service data
Attention! Danger of data loss! Do not disconnect the USB stick from the device during ongoing data
transfer!
After successful transfer, the controller shows again the initial function “Import configuration”.
22.3.5 Error during data transmission
In the event of an error, the message ERR (error) is displayed.
Read error (example).
Import configuration.
22.3.6 Removing the USB stick
Logging off the USB stick is not possible / required.
Be sure that no data recording is running (chap. 22.3.4).
After removing the USB stick, the controller is back in the same menu as before when connecting the
USB stick.