28
Clinician's Guide
H200 Wireless Clinical Programs
The H200 Wireless System supports:
• Functional Training Programs.
• Neuroprosthesis Programs.
• Motor Neuromodulation Program.
• Personal Preset Programs.
• Custom Personal Programming
Functional Training Programs
There are three functional Training Programs A, B, and C that are designed to exercise the
hand. They consist of repetitive motions with a relaxation pause between each motion. They
begin when the
trigger button on the Control Unit or Orthosis is pressed. They end when
the programmed training time finishes. Training time can range from 5 to 120 minutes.
Program A—Grasp and Release
Activates sequential opening and closing of the hand. Pressing the trigger button starts the
stimulation to open the hand. The hand then closes and opens, with a pause between each
phase. Stimulation intensity and the duration of the extension and flexion phases can be
adjusted, as can total program time.
Program B—Open Hand
Activates the extensor muscles only. When the trigger button is pressed, hand extension is
followed by a period of relaxation, and then hand extension repeats. Stimulation intensity and
the duration of the extension and relaxation phases can be adjusted, as can total program
time.
Program C—Grasp
Activates sequential closing of the hand. When the trigger button is pressed, hand flexion is
followed by a period of relaxation, and then hand flexion repeats. Stimulation intensity and
the duration of the flexion and relaxation phases can be adjusted, as can the total program
time.
To Next Page
Loading...
