75
Chapter 8 - NESS H200 Wireless Software
Figure 8-16: Control unit not registered message.
Data Inconsistency
Message appears when the data stored in the Clinician’s Programmer database and on the
NESS H200 Wireless System differ. See Figure 8-17. A data inconsistency can occur when
two Clinician’s Programmers are used to program the system. Do one of the following:
• Press System to overwrite the data in the Clinician’s Programmer database with that on
the NESS H200 Wireless System.
• Press Database to overwrite the data on the NESS H200 Wireless System with that in
the Clinician’s Programmer database.
• Press Ignore to make no changes to either data set.
Figure 8-17: Data inconsistency message.
To Next Page
Loading...
