Bioness NESS H200 Wireless - Wrist Insert; Wrist Insert Screws; Wrist Insert Covers

40
Clinician's Guide
Wrist Insert Screws
One wrist insert screw is needed to attach the wrist insert to the wrist bridge of the H200
Wireless Orthosis. See Figure 5-4.
Wrist Insert Covers
The wrist insert cover adheres to the wrist insert and is used as an hygienic cover when the
Orthosis is used by multiple patients. Two sizes are available: small/medium and large. The
wrist insert cover is single use only. See Figure 5-5.
Wrist Insert
The wrist insert is a removable unit that attaches to the underside of the wrist bridge of the
Orthosis. See Figure 5-4. It is used to cushion the back of the hand, maintain contact pressure
between the Orthosis and the hand in order to stabilize the hand, and optimize hand posture
during stimulation. The wrist insert is available in right (Rt) and left (Lt) configurations, and in
three sizes (thick, medium, and thin).
Figure 5-4: Wrist insert and wrist insert screw.
Wrist Insert Screw
Wrist Insert