32
Clinician's Guide
Turning On Stimulation
Press the trigger button on the H200 Wireless Control Unit or the trigger button on the
Orthosis.
Pausing Stimulation
Press the trigger button on the H200 Wireless Control Unit or the trigger button on the
Orthosis.
Note: Neuroprosthesis Programs cannot be paused. Pressing the trigger button when
stimulation is on starts the second phase of a Neuroprosthesis Program.
Turning Off Stimulation
Press the on/off button or the trigger button on the Control Unit, or press the trigger
button on the Orthosis.
Note: To stop stimulation immediately press the
on/off button in a Neuroprosthesis
Program.
Adjusting Stimulation Intensity
Press the plus or minus button on the Control Unit once to increase/decrease
stimulation intensity one level. The Control Unit will beep with each change in level and it will
show in the digital display.
Note: An intensity level of “0” equals no stimulation.
Muting/Un-Muting the System Audio Alerts
Press the mute button briefly. The mute button is located on the side of the Control Unit.
Entering and Exiting Deep Sleep Mode
With the system off, press and hold the on/off button for ten seconds. The Control Unit
and Orthosis will beep and the Orthosis lights will flash when entering deep sleep mode. To
exit deep sleep mode, press the Orthosis trigger button.
Note: Deep sleep mode is a power saving feature that shuts down the system and displays
no indications. The use of deep sleep mode is recommended for extended periods of
non-use.
To Next Page
Loading...
