44
Enable+ (Pin 1) and Enable- (Pin 14) are opened, the button is
disabled and the power supply’s output will remain OFF. Pressing the
button will not turn ON the output, and the display will also show
ENA.
When Enable+ (Pin 1) and Enable- (Pin 14) are shorted, the button
is enabled. This will enable the button to allow front panel control
of the output state. If the ENA is shown on the LCD screen, press
once so that it disappears before attempting to press the button.
BMODE
This mode allows enabling or disabling the power supply’s output using
the Enable+ (Pin 1) and Enable- (Pin 14). It will also disable the
button.
When Enable+ (Pin 1) and Enable- (Pin 14) are opened, the output is
OFF.
When Enable+ (Pin 1) and Enable- (Pin 14) are shorted, the output is
ON.
To Next Page
Loading...
Need help?
General
