63
2. Use the rotary knob to select the setting of OFF or ON.
3. Use the buttons to move the cursor to the PROGRAM
selection and use the rotary knob to select a program between
1-9.
4. Use the buttons to move the cursor to the EDIT
selection and press . The following screen will be displayed:
5. As described previously, each step has the following parameters
to be edited: step number, action, voltage, current, and time.
Use the buttons to move the cursor to the desired
parameter and use the rotary knob or keypad (numeric values
only) to change the parameter values. Change the step value
and continue this procedure for each step for as many steps as
needed.
6. Once an END action step is entered, pressing will finalize
the program steps and the following will be displayed:
To Next Page
Loading...
