64
7. At this point, the user may select how many times they wish the
current program to repeat in the REPEAT field, by using the
keypad or the rotary knob.
8. Press to select NEXT PROG parameter and use the rotary
knob to select a value of NONE or a value of 1-9. As described
previously, the user has the ability to queue another program
once the current program is finished. By default, NONE is placed
as the parameter value.
9. Press to complete the program configuration.
10. Make sure the program is turned ON and press to exit the
program settings.
11. Once the output state is enabled, by pressing , the program
will automatically execute. The following will be displayed when
the program is executing:
When program mode is running, an * indicator on the display will flash
to indicate the program is running. The current program (PRG: p), step
(S: sss) and repeat number (R: xx / yy) will also show on the display.
Where p is the program number, sss is the step number, xx is the
present repeated number and yy is the total repeat number. For
To Next Page
Loading...
Need help?
General
