BMS alpha CR - Diesel Motor and Charge Indicator Errors

9
Troubleshooting
9.4
List of possible errors
128
Error
Possible cause
Remedy
Charge control display
of the multifunction
display does not turn
green after the starting
procedure.
The cable connection is loose.
Have the cable connections checked
by a qualified electrician, if necessary
have the cables replaced.
The cables are defective.
Check the cables, have them replaced
if necessary.
The connections are oxidized.
Have the connections checked by a
qualified electrician, if necessary have
them replaced.
The alternator is defective.
Have the alternator checked by a
qualified electrician, repair if
necessary.
Diesel motor
Motor does not start.
The battery is too weak.
Check the battery, recharge it.
Carry out a jump start (see Section
9.6)
Replace the battery if necessary.
The "Start/stop motor" button is
defective.
Have the "Start/stop motor" button
checked by a qualified electrician and
replaced if necessary.
The starter motor is defective.
Check the starter motor and have it
replaced if necessary.
There is too little fuel in the tank.
Check the fill level in the tank.
The fuel prefilter and/or the fuel filter
are dirty.
Check the fuel prefilter and/or the fuel
filter, replace if necessary.
The dome screen indicator on the
multifunctional display lights up red.
Check that the dome screen is present
and correctly inserted.
The motor stops
immediately after the
"Start/stop motor" button
is released.
Problems with the safety chain, oil
pressure and oil temperature.
Check the fluid levels and check the
safety switches and have them
replaced by a qualified electrician if
necessary.
Cable connections on safety switches
have come loose.
Have the cable connections checked
by a qualified electrician, if necessary
have the cables replaced.
The fuel prefilter and/or the fuel filter
are dirty.
Check the fuel prefilter and/or the fuel
filter, replace if necessary.
The alternator is defective.
Check the alternator, repair if
necessary.