Operation in working mode
105
7.7.2 Closing the mixing and delivery vessel
Risk of injury due to pressure loss in the mixing and delivery vessel.
Material jamming, ageing or other incidents can cause cracks and leaks.
This leads to pressure loss in the mixing and delivery vessel, which can
cause material to escape and cause serious injuries.
− Do not stay in or close to danger zones.
− Replace a damaged rubber seal on the dome cover immediately.
1. Make sure that the edge of the dome has been cleaned.
2. Check the rubber seal on the dome cover for damage and replace it if
necessary.
3. Close the dome cover.
Figure 54: Dome cover closed
4. Fold the vessel vent (1) to the rear stop.
5. Press the dome cover down on the handle (2).
6. Press the toggle lock over the baffle.
7. Push the lever (3) of the toggle lock down as far as it will go.
8. Close the vessel ventilation (1) and secure the toggle lock.
➢ The lid of the mixing and delivery vessel is now closed and
secured against unintentional opening.
To Next Page
Loading...