Risk of injury due to pressurized components.
The delivery hoses are under pressure and opening the hose couplings
can cause severe injuries.
− Before opening, stop the machine and ensure that the delivery hoses
are depressurized.
− Wear safety goggles. Residual pressures cause the conveyed material
to be discharged at an accelerated rate when the hose couplings are
opened.
− If conveyed material gets into the eyes, wash them out thoroughly and
consult a doctor immediately.
1. Run the mixing and delivery vessel until empty. Collect residual material
and dispose of it in an environmentally friendly manner.
➢ Follow the instructions for the material used.
2. Wash the entire machine from the outside with water and a hand brush.
3. Pump the mixing and delivery vessel empty at a low speed while adding
clear water.
4. Wash off any remaining material with a strong water jet.
5. Switch off the motor using the "Start/Stop motor" button.
6. Disassemble the delivery hose line.
7. Clean the delivery hose inside and outside (see Section 8.5.4). Clean
the hose couplings and the associated seals in particular with clear
water.
8. Preserve the machine with a biodegradable BMS machine care
product.
9. Install the rear light unit and connect it electrically to the trailer (see
Section 6.4).
To Next Page
Loading...