28
2.11 Spare parts
Only original spare parts specified by BMS may be used. The information in
the parts lists or spare parts lists is decisive in this case.
Other components not supplied by the manufacturer can influence the safety
functions and the behaviour of the machine. They are therefore not
permitted for use.
Spare parts that have exceeded the maximum use-by date may no longer be
used.
When ordering spare parts, state the machine type, chassis number and the
designation from the spare parts list.
2.12 Structural changes
Structural changes, additions and conversions to the machine may only be
carried out with the written approval of the manufacturer.
Unauthorised modifications invalidate the declaration of conformity. The
warranty becomes void.
2.13 Disposal
Legal national and community regulations for environmental protection and
disposal must be observed in the handling of the machine. In-company
regulations must be compared with the appropriate manufacturer’s
information and adjusted, if necessary.
Incorrect or negligent disposal can cause considerable environmental
pollution.
− Observe the handling and disposal regulations in the safety data sheets
of hazardous substances.
− Do not discharge any operating and auxiliary materials into the sewer
system, the ground or water bodies.
− Collect and dispose of oils/greases accordingly
− Dispose of / recycle any hazardous wastes (e.g. circuit boards, cables,
plastic materials, etc.) and any replacement parts properly.
To Next Page
Loading...