EasyManua.ls Logo

BMS alpha CR - Identification of Residual Hazards

Default Icon
188 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Safety
2.7
Residual hazards
20
2.7 Residual hazards
The machine was subjected to a risk assessment. The hazards determined
in doing so were, in as much as possible, removed and detected risks
reduced. But the machine still harbours residual risks which are described in
the following section.
The warnings and safety instructions listed in here and in the action chapters
of these instructions must be observed without fail in order to prevent
possible damage to health and dangerous situations.
Danger zones which cannot be avoided due to the construction of the
machine are marked with warning signs.
2.7.1 Warning signs on the machine
CAUTION
Risk of injury through illegible signs.
Labels and signs that have become blurred or illegible no longer
sufficiently mark danger points and cannot indicate possible risks of injury.
Keep pictograms, safety, warning and operating instructions in
perfectly legible condition at all times.
Replace damaged or illegible pictograms, marks, signs or labels
immediately.
Pictogram
Location
Explanation
On the battery,
On the generator
Dangerous electrical voltage
warning
On the motor
Hot surfaces warning
At the front
Hand injury warning
On the battery
Warning against burns

Table of Contents