EasyManua.ls Logo

BMS alpha CR - Delivery Hose Connection Hazards

Default Icon
188 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Work mode
7
Connecting delivery hoses
7.4
83
7.4 Connecting delivery hoses
WARNING
Tripping hazard from faulty laying of delivery hoses.
The delivery hoses laid on the floor pose a tripping hazard and thus a
falling risk.
During installation of the machine, ensure that the delivery hoses are
covered or labelled appropriately.
If possible, lay delivery hoses so that they do not pose a hazard for
transportation and passenger traffic.
Observe the regulations of the trade associations, especially the
accident prevention regulations.
WARNING
Danger of injury due to defective or tearing off delivery hoses.
Torn or broken or defective delivery hoses and couplings can cause
personal injury and considerable material damage.
Only use delivery hoses with an operating pressure of at least 10 bar
and a minimum diameter of 50 mm.
Do not use different minimum diameters. This can lead to blockages.
The machine may be operated only with mounted discharge stand.
Use only approved and non-defective delivery hoses and couplings.
NOTE
According to the safety inspection sheet for the proper condition of the
delivery hoses and their couplings, the following checks must be carried
out:
Hoses for wear
Hoses for cracks and fabric damage
Couplings for wear
Weld seams for function and breakage.
If damaged or worn, replace delivery hoses and couplings immediately.
Make sure that the operating pressure is correct.

Table of Contents