BMS alpha CR - Chassis Maintenance Schedule

10
Maintenance
10.5
Maintenance schedules
142
10.5 Maintenance schedules
10.5.1 Maintenance schedule chassis
Personne
l
Interval
Maintenance
Comment
After 50 km
Check the firm seat of
the wheel nut.
After the first 50 km after a wheel change,
retighten the wheel nuts with a torque spanner.
Observe the tightening torque in doing so (see
Section 3.1).
After 50 km
Before driving
Check tyre pressure.
Check the tyre pressure after the first 50 km
after a wheel change and then weekly (see
Section 3.1).
Before driving
Check the condition
of the tyres.
Tread depth must be at least 2 mm.
Note:
Pay particular attention to tyre damage caused
by construction site operation.
Before driving
Perform a visual
inspection of the rear
light unit for the
following items:
− Illuminant
undamaged,
− Cables and plug
connections.
Replace defective or damaged illuminants,
cables and plug connections.
Before driving
If an optional feeder
is used, secure it
against sagging with
a lashing strap.
Observe road traffic regulations.
Before driving
Secure the scraper
with the spring cotter
pins.
After 200 km
Check toothed belt
tension and adjust if
necessary.
Have the brake system checked on a brake
tester in a specialist workshop and readjusted if
necessary.
Note:
Only after the first 200 km, then as required.
Weekly
Grease the chassis.
Grease all moving parts with grease or spray
grease.
Weekly
Preserve the
machine.
Spray the machine with preservative agent
(see Section 11.4).