BMS alpha CR - Machine Daily Maintenance Checks

10
Maintenance
10.5
Maintenance schedules
146
Personne
l
Interval
Maintenance
Comment
Daily before starting
up
Check the function of
the dome screen
safety device.
Operate the dome screen safety device with
the master key.
Clean and grease the lock carefully.
Note:
The machine must not be operated without the
dome screen safety device functioning
properly.
Daily before starting
up
Check the fuel level.
Fill up fuel before starting work
Fuel: Diesel (DIN EN 590)
Daily before starting
up
Check motor oil level.
Check the oil level with the oil dipstick (see
Section 7.5).
The oil level must be between min. and max. If
necessary, top up motor oil to the max. mark.
Lubricant/s: BMS 10 W 40 LA low-ash
Daily before starting
up
Check cooling water
level.
Check the cooling water level at the reservoir
(see Section 7.5).
If necessary, top up with water and cooling
machine protective agent according to the
manufacturer's specifications.
Daily before starting
up
Check hydraulic oil
level.
Check the hydraulic oil level with the oil dipstick
in cold condition (see Section 7.5).
The hydraulic oil level must be between min.
and max. If necessary, top up hydraulic oil up
to the max. mark.
Daily before starting
up
Check compressor oil
level.
Check the oil level with the oil dipstick (see
Section 7.5).
The oil level must be between min. and max. If
necessary, top up the compressor oil to the
max. mark.
Daily before starting
up
Check delivery hoses
and hose couplings.
Replace the delivery hoses and hose couplings
as soon as damage to the delivery hoses and
hose couplings is detected.
Daily
Check the grease
nipples of the dome
cover and locking
lever, lubricate if
necessary.
Grease dome cover and locking lever regularly.
To do this, lubricate the grease nipples with 2
blows from the grease gun.
Daily
Check the seal of the
dome cover.
If the seal is porous or damaged, if material
residues have pressed themselves into the
seal, replace it.