Check the condition
of the mixing shaft
bearing.
Have the mixing shaft bearing replaced in a
specialist workshop if necessary.
Lubricate the grease
nipple on the rear,
outer mixing shaft
bearing.
Lubricate the rear, outer mixing shaft bearing
with 4 strokes from the grease gun.
Grease lubrication
points.
Grease must escape through the bearings after
lubrication. Otherwise, a defective lubrication
line may prevent the bearings from being
greased.
Check the steel cable
of the scraper shovel.
In case of damage (including individual, torn
steel threads) replace the steel cable.
Check the grease
nipples of the
tensioning rocker in
the motor
compartment,
lubricate if necessary.
Grease the tensioning rocker regularly.
To do this, lubricate the grease nipples with 2
blows from the grease gun.
To Next Page
Loading...