54
Save reset button (3)
This key has two functions, depending on the length of actuation: Save and
reset.
Saving the address
1. Press the button (3) for 1 second. The red LED lights up after 1 s.
2. Operate the radio transmitter via the thumb button until the red LED
flashes.
3. Press the button (3) again for 1 s. The red LED goes out.
Resetting the address
1. Press the button (3) and keep it pressed for 3 seconds. The address is
reset.
Thumb button
Via the thumb button the cable winch of the scraper is controlled. As long as
you keep the thumb button pressed, the rope is rolled up by the winch. If the
thumb button is not actuated, the rope can be unwound via the free wheel of
the rope drum.
To Next Page
Loading...